A Campbell County deck permit comes from one of three offices: Campbell County Planning, Zoning & Building Inspection in Newport for the unincorporated county and most cities (Cold Spring included), the City of Newport’s own building official for Newport addresses, or Fort Thomas city inspectors when the house is single-family. Each office works from the 2018 Kentucky Residential Code, and ledger-attached decks need a permit even a step off the ground. Our overview of deck permits across the Cincinnati tri-state sets this county beside the others we serve.
Fort Thomas is roughly an hour’s drive from our Cleves shop, and the county’s river bluffs give us some of the steepest yards we build on. That combination is why the permit here starts with two lookups, the right office and the lay of the land, before anyone sketches a joist.
Fort Thomas is roughly an hour’s drive from our Cleves shop, and the county’s river bluffs give us some of the steepest yards we build on. That combination is why the permit here starts with two lookups, the right office and the lay of the land, before anyone sketches a joist.
Quick answer
9 min read
Unincorporated areas and most citiesCounty Planning, Zoning & Building Inspection
Newport addressesThe city’s own building official
Fort Thomas housesCity inspectors (single-family dwellings)
Cold SpringFiled with the county office
Code2018 Kentucky Residential Code
Parcel, flood and slope dataLINK-GIS public maps
Three offices, one county: who reviews your deck
Which office reviews your deck depends on the city line, not the county line, so the address decides it. Kentucky’s Campbell County jurisdiction sheet lists the county as the local building office for Alexandria, Bellevue, California, Crestview, Dayton, Highland Heights, Melbourne, Silver Grove, Southgate, Wilder, Woodlawn and the unincorporated county. It lists the City of Newport separately, with its own building official, and the City of Fort Thomas separately for single-family dwellings.
Cold Spring isn’t named on that sheet, but the city’s own code designates the county’s building inspection department, so Cold Spring decks are filed with the county office at 1098 Monmouth Street in Newport. Fort Thomas is the subtle one: the city reviews single-family houses itself, while other building types in Fort Thomas go to the county. A deck on a single-family home therefore goes to the city.
Cold Spring isn’t named on that sheet, but the city’s own code designates the county’s building inspection department, so Cold Spring decks are filed with the county office at 1098 Monmouth Street in Newport. Fort Thomas is the subtle one: the city reviews single-family houses itself, while other building types in Fort Thomas go to the county. A deck on a single-family home therefore goes to the city.
Campbell County deck permits by city
| Where the house is | Reviewing office | Phone |
|---|---|---|
| Fort Thomas (single-family home) | City of Fort Thomas | (859) 572-1210 |
| Newport | City of Newport building official | (859) 292-3637 |
| Cold Spring | Campbell County Planning, Zoning & Building Inspection | (859) 292-3880 |
| Alexandria, Bellevue, Dayton, Highland Heights, Southgate and other listed cities | Campbell County Planning, Zoning & Building Inspection | (859) 292-3880 |
| Unincorporated Campbell County | Campbell County Planning, Zoning & Building Inspection | (859) 292-3880 |
What the county's maps tell us before we draw
Before we draw anything we pull the parcel’s flood, contour and soil information, because in this county those three facts shape the deck more than the board choice does. The county’s Planning, Zoning & Building Inspections page points residents to LINK-GIS, the Northern Kentucky mapping system serving Campbell, Kenton and Pendleton counties, for property information including flood zone, topography and soil types. The LINK-GIS viewer searches by address, parcel number or owner, and it is the same source we check during design.
Flood information matters along the Licking River and the low ground near the Ohio. Newport’s 1948 floodwall protects much of the city, but parcels near the Licking still get a look at the flood map before footing heights are set. Topography matters almost everywhere else. Fort Thomas sits on hills and valleys above the river, and a yard that looks gentle at the back door can drop a full story by the lot line. Soil type tells us what the footings are likely to bear on, which we then confirm by digging, since the map is a starting point and not a substitute for seeing the ground.
Flood information matters along the Licking River and the low ground near the Ohio. Newport’s 1948 floodwall protects much of the city, but parcels near the Licking still get a look at the flood map before footing heights are set. Topography matters almost everywhere else. Fort Thomas sits on hills and valleys above the river, and a yard that looks gentle at the back door can drop a full story by the lot line. Soil type tells us what the footings are likely to bear on, which we then confirm by digging, since the map is a starting point and not a substitute for seeing the ground.
- Parcel lines and lot dimensions
- Mapped flood zone, if any
- Contours across the deck footprint
- Soil type under the footing locations
- Which city, if any, the parcel sits in
Lit second-story composite deck above a screened under-deck room on a brick home at dusk
Zoning in Campbell County depends on where you live
Setbacks and other zoning rules come from different places depending on the city, so the county’s rules only apply to some addresses. The county’s own page notes that its Zoning Ordinance pertains to unincorporated Campbell County only, and that the Campbell County & Municipal Planning & Zoning Commission represents the unincorporated county plus the cities of Crestview, Melbourne, Silver Grove, Southgate and Woodlawn.
A deck in Fort Thomas, Newport or Cold Spring therefore sits outside the county ordinance’s reach for setbacks, even where the county reviews the building side, so the city’s own rules are the ones we check. We check with the right city hall during design and draw the footprint to fit, so the setback question is settled before framing is drawn.
Newport adds one more layer. Inside the East Row and Mansion Hill district, a street-facing deck may face a design review before any permit is issued. We plan for that step and add it to the schedule rather than finding out at the permit counter. Where a subdivision has its own exterior review, the drawing set we prepare goes to that committee and to the permit office alike.
A deck in Fort Thomas, Newport or Cold Spring therefore sits outside the county ordinance’s reach for setbacks, even where the county reviews the building side, so the city’s own rules are the ones we check. We check with the right city hall during design and draw the footprint to fit, so the setback question is settled before framing is drawn.
Newport adds one more layer. Inside the East Row and Mansion Hill district, a street-facing deck may face a design review before any permit is issued. We plan for that step and add it to the schedule rather than finding out at the permit counter. Where a subdivision has its own exterior review, the drawing set we prepare goes to that committee and to the permit office alike.
Talk it through with us
Send a few photos or book a visit and we’ll walk you through the options for your yard.
Steep lots in Fort Thomas and along the river
A steep yard changes what the inspector looks at, and on Campbell County’s hillsides that usually means footing placement, post heights and bracing. Kentucky’s code leaves the frost depth to local officials, so every pier we set goes deeper than the figure that office uses, and in Fort Thomas and Newport we take that figure from the city inspector before digging. On a slope, the downhill footings also have to sit far enough into the hill to stay stable, and that can set their depth or position as much as frost does; we design for it and the inspector checks it.
Tall posts need lateral bracing and the drawings show it, along with the ledger detail and the guard heights at every edge. On the steepest lots, helical piers are sometimes the better foundation, and our planning ranges put them at $2,500–7,000 extra, a figure we only firm up after seeing the slope in person. A sloped site adds roughly 10–20% to the structure in those same ranges, and the deck cost calculator applies it automatically.
Our hillside and sloped-yard deck work is built around these lots: we measure the grade, design the structure to it and walk the inspector through it at each visit. The Fort Thomas deck page covers the city’s process in more detail.
Tall posts need lateral bracing and the drawings show it, along with the ledger detail and the guard heights at every edge. On the steepest lots, helical piers are sometimes the better foundation, and our planning ranges put them at $2,500–7,000 extra, a figure we only firm up after seeing the slope in person. A sloped site adds roughly 10–20% to the structure in those same ranges, and the deck cost calculator applies it automatically.
Our hillside and sloped-yard deck work is built around these lots: we measure the grade, design the structure to it and walk the inspector through it at each visit. The Fort Thomas deck page covers the city’s process in more detail.
What we ask you for, and what we take care of
You supply a few documents and decisions; we turn them into the permit set and carry it through review. Most homeowners have more of what’s needed than they think, usually in the closing folder from when they bought the house.
The plat or survey tells us where the lot lines and any recorded easements are, which matters on the narrow, deep lots common in Newport and Bellevue. Photos of the wall where the deck will attach help us plan the ledger before the site visit, and on brick or stone houses they show early whether a freestanding design is worth discussing. If a subdivision or historic-district review applies, the governing documents tell us what that committee wants to see.
From there, our side covers the measurements, the 3D design, the framing and footing drawings, the application to the right office, replies to plan-review comments and every inspection visit. One proposal covers the design, the permit and the build, and nothing goes to an office until you’ve approved the design it shows.
The plat or survey tells us where the lot lines and any recorded easements are, which matters on the narrow, deep lots common in Newport and Bellevue. Photos of the wall where the deck will attach help us plan the ledger before the site visit, and on brick or stone houses they show early whether a freestanding design is worth discussing. If a subdivision or historic-district review applies, the governing documents tell us what that committee wants to see.
From there, our side covers the measurements, the 3D design, the framing and footing drawings, the application to the right office, replies to plan-review comments and every inspection visit. One proposal covers the design, the permit and the build, and nothing goes to an office until you’ve approved the design it shows.
- Plat, survey or deed with the lot dimensions
- Photos of the house wall and the yard from a few angles
- Any subdivision or historic-district review documents
- Your plans for a hot tub, roof or lighting, so the framing is sized once
- A rough budget, so the first design lands close
Elevated composite deck with black posts and stainless steel cable railing
Code, inspections and our role in Campbell County
The Kentucky edition all three offices use is the 2018 Kentucky Residential Code; the state’s adopted-codes list traces it to the 2015 International Residential Code. A ledger-attached deck gets a permit at every height. A small platform that stands on its own close to grade can sometimes skip the building permit, though setbacks still govern where it goes; before relying on that, we get the current size and height limits from the reviewing office.
Inspections come at the footing stage with the holes open, at framing before decking goes down, and at final. A member of our team is there for each one, which matters on a job an hour from the shop, so we plan site visits and inspection days to keep the schedule tight.
The license number we publish, CBRC006414, belongs to an Ohio residential builders license, and we make no claim to a Kentucky one; in Campbell County we work under the permit of whichever office has your address and meet any registration it requires. Our crews typically finish a deck in one to three weeks after the office signs off on the permit, with complex designs, slow material deliveries or rain stretching it, and our proposals carry the permit as a separate $150–500 allowance until the real fee is known. Our Newport deck page and the Campbell County service area page cover the rest of the county.
Inspections come at the footing stage with the holes open, at framing before decking goes down, and at final. A member of our team is there for each one, which matters on a job an hour from the shop, so we plan site visits and inspection days to keep the schedule tight.
The license number we publish, CBRC006414, belongs to an Ohio residential builders license, and we make no claim to a Kentucky one; in Campbell County we work under the permit of whichever office has your address and meet any registration it requires. Our crews typically finish a deck in one to three weeks after the office signs off on the permit, with complex designs, slow material deliveries or rain stretching it, and our proposals carry the permit as a separate $150–500 allowance until the real fee is known. Our Newport deck page and the Campbell County service area page cover the rest of the county.
Related reading
Building a Deck on a Cincinnati Hillside Lot
From our guide: Deck Permits, Codes and Inspections in the Cincinnati Tri-State.
Kenton County, KY Deck Permits: PDS, Independence and Covington
From our guide: Deck Permits, Codes and Inspections in the Cincinnati Tri-State.
Deck Railing Height Code in Ohio, Kentucky and Indiana
From our guide: Deck Permits, Codes and Inspections in the Cincinnati Tri-State.
Campbell County deck permit questions
Who issues a deck permit in Fort Thomas, KY?
For a single-family home, the City of Fort Thomas, which inspects single-family dwellings itself according to Kentucky’s Campbell County jurisdiction sheet; its number is (859) 572-1210. Other building types in Fort Thomas go to the county office. We prepare and file the application and meet the city inspector on site.
Does Newport, KY use the Campbell County building office?
No. Newport has its own building official, at (859) 292-3637, who reviews deck permits for Newport addresses. In the East Row and Mansion Hill district a deck may also need design review, which we plan into the schedule.
Where do Cold Spring deck permits go?
To the county’s Planning, Zoning & Building Inspection office in Newport, (859) 292-3880, because Cold Spring’s city code designates the county’s building inspection department. Setbacks still follow Cold Spring’s own rules.
What footing depth applies to a Campbell County deck?
Below the frost depth the reviewing office sets, since Kentucky leaves that figure to local officials, and deeper where a slope or load calls for it. Unlike the Ohio side of the Cincinnati area, we don’t carry a single number across the river; we confirm it with the county, Newport or Fort Thomas first.
Will a steep Fort Thomas or Newport yard work for a deck?
Usually, yes. Engineering decks for sloped tri-state lots is one of our specialties. We check the parcel’s contours and flood data, design the footings and bracing to the grade, and confirm footing depth and any helical piers on site before the proposal is final.
Sources
Campbell County, KY: Planning & Zoning & Building Inspections (services, address and phone; zoning ordinance scope; LINK-GIS for flood zone, topography and soils)
Kentucky Department of Housing, Buildings and Construction: Campbell County jurisdiction sheet (county coverage; City of Newport; City of Fort Thomas single-family dwellings)
LINK-GIS: Northern Kentucky Geographic Information System (parcel, flood and zoning map viewers)
Kentucky Department of Housing, Buildings and Construction: codes currently adopted by Kentucky (2018 KRC based on the 2015 IRC)
Kentucky Department of Housing, Buildings and Construction: Campbell County jurisdiction sheet (county coverage; City of Newport; City of Fort Thomas single-family dwellings)
LINK-GIS: Northern Kentucky Geographic Information System (parcel, flood and zoning map viewers)
Kentucky Department of Housing, Buildings and Construction: codes currently adopted by Kentucky (2018 KRC based on the 2015 IRC)