Deck Post Rot and Footing Problems: Causes, Signs and Fixes

Posts and footings carry the whole deck. Why posts rot, why footings heave or sink in a freeze-thaw climate, what deck guidance requires and how one post gets replaced.
Gloved hands checking a deck ledger connection and joist hangers with a level
Deck posts usually rot at the base, where the wood sits in soil, mulch or standing water, and footings fail when they are too shallow for frost, too small for the load, or sitting on loose fill. A rotted post can often be replaced on its own: the deck is shored up, a new post goes onto a sound footing with a metal post base, and the beam is reconnected. The fix is bigger when several footings have moved. Our guide to deck repair and safety through Ohio seasons covers the rest of the structure.

Posts and footings are the part of a deck people look at least, yet they hold up everything else. Ohio jurisdictions around Cincinnati want deck footings dug past the frost line, a depth they each fix somewhere between 30 and 36 inches, and many older decks around Cincinnati were built before anyone checked. We are Building Character, a licensed Ohio builder working from Cleves since 1994, and replacing posts and resetting footings is a regular part of the structural repair work we do on older decks.

Quick answer

9 min read

Where posts rotThe bottom few inches, at or below grade
Minimum post size (AWC DCA 6)6×6 nominal
Footing depth, Southwest OhioUnder the frost line: 30–36 in., varies by town
Kentucky and IndianaEach county’s building office sets the depth
Freeze-thaw swings per yearRoughly 57 in Cincinnati (NCEI)
RepairsConfirmed on site; a permit may be required

The most common post and footing problems

Most post and footing trouble falls into a handful of patterns, and you can spot several of them yourself with a flashlight, a level and a few minutes under the deck. Some are simply age. Others are shortcuts that were common when many tri-state decks went up and that current guidance no longer allows.
Post and footing problems we find on older decks
ProblemWhat you’ll noticeUsual cause
Rot at the post baseSoft, dark or crumbling wood near the ground; a screwdriver sinks inPost buried in soil or mulch, or set in a puddle
Frost heaveDeck or stairs higher in winter, gaps that open and close by seasonFooting above the frost line
Settling or sinkingA low corner, a sagging beam, boards that slope away from the houseFooting too small or poured on loose fill
Post off its footingPost bearing on the edge of the concrete, or beside itFooting poured in the wrong spot or shifted
Beam bolted to the side of the postThrough-bolts carrying the full load, no notch or capAn older method current guides prohibit
Undersized postsTall 4×4 posts on a raised deckBuilt before 6×6 became the guide minimum
Rusted connectorsFlaking post bases, bolts or bracketsWrong coating for treated lumber, or constant wetting

A quick check you can do

Put a level on each post, both directions. Push firmly on the railing at each corner and watch the post below for movement. Probe the bottom of each post with a screwdriver, digging a little soil away if the post goes into the ground. Then look at how the beam sits on top: it should bear on a notch or sit in a metal post cap, not hang from bolts alone. Anything that fails one of those checks deserves a professional look.

Why deck posts rot at the bottom

Posts rot from the bottom because that is where they stay wet: in contact with soil, buried in mulch, sitting in a low spot where water pools, or set in concrete that holds water against the end grain. Treated lumber resists decay, but its protection depends on being rated for the exposure and on the cut end being treated.

DCA 6, the prescriptive deck manual published by the American Wood Council, requires all lumber in contact with the ground to be preservative-treated for ground contact, and it says the cut ends and notches of posts get a brushed-on preservative in the field, with copper naphthenate given as an example. Too often we find posts cut to length on site with the raw end buried, which is the exact spot rot begins.

The better detail keeps the wood out of the ground entirely. A post that sits on top of a concrete footing in a galvanized or stainless metal post base, which is what DCA 6 calls for in pre-manufactured anchors, stays dry at the bottom and is easy to inspect. Keeping mulch beds and soil pulled back from the posts helps as well, and our post on moisture and rot under decks covers drainage and airflow under the frame.
Elevated composite deck with black aluminum balusters along a brick and siding home
Elevated composite deck with black aluminum balusters along a brick and siding home

Frost heave and footing depth in the tri-state

Footings move in winter when they sit above the depth where the ground freezes, because freezing soil expands and lifts whatever rests on it. The NCEI engineering weather summary for Cincinnati puts Cincinnati’s yearly tally of freeze-thaw cycles at 57, which means a footing that is too shallow can be pushed up and let down many times each winter. Over years that shows up as a deck that is no longer level, stairs that pull away, and connections that loosen.

On the Ohio side, we dig until we are under the frost line, which the permitting town or county fixes at 30–36 inches. Fairfield is a good example: its deck and porch permit page tells builders that piers and other permanent supports go down to a 30-inch frost line. In Kentucky and Indiana the county building office names the depth, and that is the number we dig to.

Depth is not the only rule. DCA 6 says footings must bear on undisturbed soil at least 12 inches below the ground surface or below the frost line, whichever is deeper, and that deck footings closer than 5 feet to a house foundation must bear at the same elevation as the house footing. That second rule matters next to a basement, where the soil was dug out and backfilled when the house was built.

Footings are inspected before the concrete goes in

On a permitted deck, the footing holes are inspected before concrete is poured, followed by framing and final inspections. Our team handles the permit with whichever local office has jurisdiction, for example in Butler County or Hamilton County, and schedule those inspections as part of the job. Footing repairs on an existing deck can need a permit too; we check with the local office before starting.

Talk it through with us

Send a few photos or book a visit and we’ll walk you through the options for your yard.

How a post should connect to the beam

The beam should bear directly on the post, sitting in a notch cut into the post’s top or in an approved metal cap, not hang off the side on bolts. DCA 6 is specific: posts must be 6×6 nominal or larger, centered on their footings, and attached to the beam by notching or a post cap, and a beam fastened to a post’s face with no notch is not allowed. All 3-ply beams need a post cap.

The guide also explains why it asks for 6×6 posts when the International Residential Code’s column minimum is a 4×4: a 4×4 would often be overstressed in the decks it covers, and a 6×6 gives the beam adequate bearing. Plenty of older decks around Cincinnati stand on 4×4 posts, and on a low deck they may be fine. On a raised deck, they are one of the first things we look at.

Bracing is the other piece. DCA 6 calls for diagonal bracing at each corner post taller than 2 feet, fastened with half-inch lag screws, though a freestanding deck with no ledger may skip it at the beam and posts next to the house. Missing or rotted bracing is a common reason an otherwise sound deck feels like it sways.

How we repair posts and footings

A single rotted post or failed footing can usually be fixed without taking the deck apart. The deck is shored with temporary supports, the old post is cut out, the footing is checked and replaced if it is too shallow, too small or off center, and a new treated post goes onto a metal post base. The beam is then reconnected with a proper notch or post cap, and bracing is replaced where needed.

When several footings have heaved or settled, or the posts are undersized for the height, the repair becomes more involved: new footings at the correct depth, new posts, sometimes a new beam. On steep hillside lots, such as the steep streets of the West Side and the bluffs above the Ohio River, deeper soil conditions sometimes call for helical piers instead of poured footings; on new hillside builds those can add $2,500–7,000, though nobody should price them before the soil and slope have been looked at in person. Our deck repair service covers this work, and every structural repair is confirmed in person, never from photos alone.

If the posts and footings are failing along with the ledger, the joists and the boards, repair stops making sense. At that point a new deck on new footings is often the better use of the money, and we will show you both options side by side. Our deck replacement service includes free tear-out and hauling of the old deck as long as its replacement matches or exceeds its square footage, and our post on deciding between repair and replacement explains how we weigh it.
Elevated cedar deck and timber-frame pavilion on a wooded hillside lot with steel-beam substructure
Elevated cedar deck and timber-frame pavilion on a wooded hillside lot with steel-beam substructure

Related reading

Rot Under Your Deck: Where Moisture Comes From and How to Stop It

From our guide: Deck Repair, Safety and Maintenance Through Ohio Seasons.

What Causes a Deck to Collapse, and How to Prevent It

From our guide: Deck Repair, Safety and Maintenance Through Ohio Seasons.

Repair or Replace Your Deck? An Honest Way to Decide

From our guide: Deck Repair, Safety and Maintenance Through Ohio Seasons.

Deck post and footing questions

Usually, yes. We shore the deck, remove the rotted post, check or replace the footing, and set a new treated post on a metal post base before reconnecting the beam. If several posts and footings have failed, or the frame above is rotted too, a rebuild may make more sense.
Deeper than the frost line, which Southwest Ohio jurisdictions put somewhere in the 30–36 inch range; Fairfield, for one, uses 30 inches. Whoever issues the permit gives the exact figure and inspects the holes before any concrete is poured. For decks in Boone, Kenton, Campbell or Dearborn County, the county’s building office decides the depth.
That is usually frost heave: a footing above the frost line gets lifted as the soil freezes and settles back as it thaws. NCEI’s count for the city is 57 freeze-thaw cycles a year, and a shallow footing can be nudged on many of them. The fix is a footing at the proper depth.
The International Residential Code sets a 4×4 minimum, but DCA 6 from the American Wood Council asks for 6×6 posts because a 4×4 is often overstressed. On a low deck, existing 4×4 posts may be adequate; on a raised deck, we look at them closely and often recommend replacing them.
We prefer posts that sit on top of the footing in a galvanized or stainless metal post base, so the end grain stays out of the ground and dry. Where wood does touch soil, it has to carry a ground-contact treatment rating, and every cut end needs a coat of preservative.

In this guide

Planning a deck?

Get a planning range from the calculator in a couple of minutes, then a real number from a free consultation.
Jared and Jennifer Riddell, owners of Building Character LLC
Jared and Jennifer Riddell, owners

About the author

Jared Riddell

Owner, Building Character LLC · Cleves, Ohio

Jared and Jennifer Riddell have designed and built decks and outdoor living spaces across Greater Cincinnati, Northern Kentucky and Southeastern Indiana since 1994. Jared reviews every guide on this site before it goes up, and the prices in our cost guides match the ranges in our deck cost calculator. If something here doesn’t fit your yard, call or text and you’ll talk with him or Jennifer directly.

Updated October 29, 2026

Tell us about your deck

Send a few details and Jared or Jennifer will follow up to set up your free consultation or a virtual quote.
Jared and Jennifer Riddell, owners of Building Character LLC

1

We talk through the project

By phone or text, at a time that works for you.

2

We see the space

On site or by video for a virtual quote.

3

You get a written proposal

Design, permits and construction included, with a free 3D design.
Prefer to talk? Call or text (513) 592-1103, Mon–Sat 9 AM–5 PM.

Request your free quote

Ready to plan your deck?

Tell us how you want to use the space. We’ll take it from there with a free consultation or a virtual quote.

Design, permits and construction included. Free 3D design.

Get a free quote

Tell us about the deck or outdoor project you have in mind. Jared or Jennifer will follow up to set up your free consultation or a virtual quote.

Loading the quote form…

Prefer to talk? Call or text (513) 592-1103. Mon–Sat 9 AM–5 PM.