What we check and fix on Independence decks
Our assessment starts on the ground. We look at each footing for depth, movement and cracking, then at the posts where they meet concrete, which is where rot usually starts. We follow the beams for sag and splits, sound the joists with an awl, and check every hanger, bolt and lag for corrosion or gaps. At the house, we check whether the ledger is bolted rather than nailed and whether flashing sends water out and away. Stairs and guards get a push test, and so do the post bases that hold them.
The repairs that follow are structural. Rotted joists get sistered or replaced. Failed posts come out. Their replacements stand on fresh concrete poured deeper than the local frost line, which the county building department sets. A ledger that was nailed or never flashed comes off, the wall behind it gets inspected and protected, and the new ledger goes on with proper fasteners and flashing. Corroded hardware is replaced with coated or stainless parts. Where the original frame was undersized for its span or its load, we add a beam or posts rather than hoping it holds.
If the frame is sound and only the surface is tired, the job is simpler: new boards, new rails, new treads. If most of the structure is compromised, a rebuild is usually the honest answer, and we start from new footings with the same 3D design and written proposal that a new deck gets. We also correct the water problems while we’re there, such as joist tape on top of the framing and grading or downspouts that keep water off the footings.