We start with how you use the deck after dark. A deck used for late dinners needs light at the table and the grill. A deck you mostly cross on the way to the yard needs the stairs and the path lit. A second-story deck over a patio needs light on both levels. From there we mark fixtures on the drawing: recessed lights in the stair risers, lights in the post caps and lighting along the rail where it helps. We keep the light low and aimed down, so it falls on the boards and steps instead of in your eyes or toward the neighbor’s windows.
A typical package is a transformer with six to ten fixtures. The transformer sits where it stays dry and can be reached, close to a power source, and feeds the fixtures through wire we run inside the joists, posts and risers. We pull those runs before the frame is closed in, and that is why lighting works best as part of the original deck plan. The wire stays clear of the board fasteners and away from places where water gathers under the deck.
Lighting ties into the rest of the deck. Stair lights go in with the composite risers on a
deck stairs project. Post-cap lights depend on the railing, so we choose them alongside your Preferred, Westbury or Key-Link aluminum railing, or with composite railing. If a kitchen, fire pit or pergola is part of the project, we place lights around them too, and if you want the yard lit beyond the deck, our
landscape lighting can follow the same plan.
Adding lights to an existing deck is possible, but the options depend on what we can reach. Post caps and some surface fixtures go on with little disruption. Recessed riser lights may mean new risers, and getting wire to the far side of a deck can mean lifting a few boards. We look before we promise anything, and the proposal says exactly what will be opened up and put back.